Trix 22393, Manual

11

Functions 

•  Built-in electronic circuit for operation with a conventional 

DC power pack, Trix Systems or NMRA DCC digital systems.

•  Automatic system recognition between digital and analog 

operation. 

•   The full range of functions is only available under Trix Sys

-

tems and under DCC.

•  Built-in headlights that change over with the direction of 

travel. They can be turned on and off in digital operation. 

•   Minimum radius for operation is 360 mm/14-3/16“.

Notes on digital operation 

•   The operating instructions for your central unit will give you 

exact procedures for setting the different parameters. 

•  The values set at the factory were selected to guarantee the 

best possible running characteristics. 

•  The setting done at the factory does not permit operation with 

opposite polarity DC power in the braking block. If you want 

this characteristic, you must do without conventional DC 

power operation (CV 29/Bit 2 = 0). 

No warranty or damage claims shall be accepted in those cases where 

parts neither manufactured nor approved by Trix have been installed in 

Trix products or where Trix products have been converted in such a way 

that the non-Trix parts or the conversion were causal to the defects and/

or damage arising. The burden of presenting evidence and the burden of 

proof thereof, that the installation of non-Trix parts or the conversion in or 

of Trix products was not causal to the defects and/or damage arising, is 

borne by the person and/or company responsible for the installation and/or 

conversion, or by the customer. 

Safety Notes

•  This locomotive is only to be used with the operating system 

it is designed for.

•  Analog max. 15 volts DC, digital max. 22 volts AC. 
•  This locomotive must never be supplied with power form 

more than one power pack.

•  Please make note of the safety notes in the instructions for 

your operating system.

•   The feeder track must be equipped to prevent interference 

with radio and television reception, when the locomotive is 

to be run in conventional operation. The 611 655 interference 

suppression set is to be used for this purpose. The interfe-

rence suppression set is not suitable for digital operation. 

• 

WARNING!

 Sharp edges and points required for operation.

•   Do not expose the model to direct sunlight, extreme changes 

in temperature, or high humidity. 

Important Notes

•   The operating instructions and the packaging are a compo

-

nent part of the product and must therefore be kept as well as 

transferred along with the product to others.

•   Please see your authorized Trix dealer for repairs or spare 

parts. 

•   http://www.maerklin.com/en/imprint.html