Assembly procedures for the Xdream bike
1. Firstly check the contents of the box so that it matches the contents list above.
2. Next take the leg which has a white “x-biking.com” transfer on it and fit it to the rear of the bike.
Place 2 of the long bolts through the bolt holes with 1 washer each side and tighten the nut securely
using 6mm Allen key and 17mm wrench.
Saddle
3. Next slide the bike saddle onto the seat slider from the back of the bike forward. Ensure the saddle is level
and that the nose points directly forward along the direction of the frame. Tighten the saddle securely by
tightening both nuts evenly using a 14mm wrench.
4. Next thread the saddle sensor cable with connector (To be found sticking out of the side of the seat post) up
through the front two bars of the saddle and clip the sensor cable firmly into the clip connector on the underside
of the saddle (One way fit only).
5. Allow some slack on the sensors and clip the cable to the saddle rails using a cable tie. Cut off the excess
cable tie.
6. Next remove the threaded nut only from the top of the quick release lever (To be found attached to the
saddle slider part of the seat post) and insert the threaded bolt up through the slot in the saddle slider.
With the nut positioned on top of the slider, tighten the nut onto the bolt up until the quick release lever
can be pulled back tight underneath the saddle slider.
7. Next fit the saddle height adjust mechanism securely in place ensuring that the knob is on the right hand side
(when looking forward from the back of the bike).
Pedals
8. Next fit the pedals to the crank arms. It is advised to finger tighten the pedals on to the cranks initially to
minimise risk of cross threading. The right pedal tightens in a clockwise direction. The left pedal tightens in an
anti-clockwise direction. Finally tightened the pedals as much as possible using a 15mm wrench.
page 47
page 48
Assembly and Installation
Tools required for assembly
(Some of these are required for service):
• Wrenches – 14mm, 15mm and 17mm
• Allen Keys – Full Set of long metric allen keys( from 2.5mm to 8mm)
• Philips screwdriver
• Pliers including snips
Parts List
Xdream Bike Box
• 1 Xdream bike frame (PN XBD-Frame)
Includes: 2 x Height Adjust Knob Assembly (SD10M011)
1 x Seat Post with slider (SD10S002)
• 1 Set of X-Bars (SD10X001)
• 1 Saddle (SD10S001)
• 1 Rear bike leg with x-biking transfer (SD10M012)
• 1 Box with - 2 Pedals (SD10D011)
1 Water bottle bracket (SX10M001)
4 Sets of nuts and bolts for leg attachment
1 Black square plastic cap (SD10X016)
User Interface
• 1 Xdream complete User Interface Unit (PN XBD-1000-001A)
Includes: 1 x Monitor Column (PN XBD-1000-001B)
1 x U-Shaped Cable Cover (PN XBD-1000-001C)
1 x Bike Facing Cover with 4 corner bolts (PN XBD-1000-001D)
1 x Opposite Cover with 4 corner bolts (PN XBD-1000-001E)
2 x Front bike legs with leveller feet (PN XBD-1000-039A)
