TRNDlabs SKEYE, User Manual

15

Safety Precautions

Caring For Your Drone

FCC Compliance Information (USA only)

•   For best performance, only use fresh Alkaline “AA” batteries in the 

controller.

•    After each crash, inspect your drone for worn or damaged parts.

•    The drone automatically switches off if the rotors are unable to rotate. 

Switch the power to restart the drone.

•  When not in use, store your drone in its original packaging with the 

batteries removed from the controller and drone.

•  Always recharge the battery immediately after use to prevent its 

becoming deep discharged. Please make sure to allow a pause of about 20 

minutes between finishing the flight and recharging the battery. Recharge 

the battery occasionally (suggested every 2-3 months). Failure to treat  

the battery as described above can lead to its becoming defective.

•   When transporting or temporarily storing the rechargeable battery the 

temperature should be between 5-50°C. If possible, do not store the 

battery or the drone in a car and do not expose it to direct sunlight. In 

case the battery is broiled it can be damaged or catch fire.

•   Do not submerge the drone or remote control in water. This will damage 

the electronic components, and could pose a severe risk to the built-in 

battery.

•   Keep the drone and remote away from heat sources.

•   To clean, wipe gently with a damp cloth. Avoid use of solvents, as these 

can damage the plastic components.

This device complies with part 15 of the FCC Rules. Operation is subject 

to the following two conditions: (1) This device may not cause harmful 

interference,  and (2) This device must accept any interference received, 

including interference that may cause undesired operation.

Modifications not approved by the party responsible for compliance could

void user’s authority to operate the equipment.

AW-V3-EN