TRNDlabs SKEYE, User Manual

5

4.

 The controller needs to be 

calibrated after successful binding: 

move the throttle/rotate stick to 

the full up position and then push 

the throttle/rotate stick to the full 

down position. When the LED on 

the controller and the LEDs on the 

drone are all solid (not blinking), the 

drone is ready to fly.

3.

 Push the power switch of the 

controller to the ON position. The 

controller will emit a tone to 

indicate that binding is complete. At 

the same time, the LED lights on the 

drone will start to flash slowly.

Throttle Control

Pushing the Throttle/Rotate stick forward will cause the main rotors to spin. 

The farther you push the stick, the faster the rotors will spin, causing the 

drone to lift off and gain altitude.

If you notice that the drone moves forward or to the side without you 

touching the control sticks, please adjust the trim of the drone as described in 

“Trimming”.

To start or to fly higher, push the throttle/rotate stick cautiously forwards. To 

land or fly lower, push the throttle/rotate stick cautiously backwards.

Flight Controls