18’
6335
6963
21’
8622
9477
24’
11,262
12,378
27’
14,254
15,666
30’
17,645
19,388
33’
21,293
23,403
BEADED VINYL LINER
BEAD RECEIVER
STEP 11: FILLING YOUR POOL
Whether you are filling the pool with your own
home water source or through a water-fill service,
please use the chart at right to determine the water
volume requirements for your particular size pool.
Please see your pool professional for instructions
on proper water testing and balancing.
48” Pool Wall
(40” of water)
Pool
Size
52” Pool Wall
(44” of water)
Water Gallonage per Pool Size
STEP 10: INSTALLING LINER
TIP:
To help in removing stubborn wrinkles,
a shop vacuum may be used to suck the
air out from behind the liner.. Attach shop vac
to skimmer outlet and seal with duct tape. Seal
all other openings with duct tape as well. Turn on
vac and run till wrinkles are removed. Once the
wrinkles are gone, begin filling with water. After 6”
of water is in the pool, turn off and remove the
shop vac.
BEADED VINYL LINER
BEAD RECEIVER
Clear all sticks and sharp objects from an area near
the pool that is as large as the pool itself. Remove
the liner from its carton and unfold and open the
liner. Refold the liner so that it can easily be carried
to the pool and unfold from the outside of the pool.
Check to make sure the sand in the pool is level
and that there are no sharp objects in the pool.
Place the liner into the pool while holding onto the
top of the wall section of the liner. Snap the bead
of the liner into the bead receiver around the entire
pool. Gently pull on the liner and use a soft bristle
broom to remove as many wrinkles as possible on
the bottom of the pool. Start filling the pool slowly
with water. Continue pulling gently and working the
liner with a broom as needed. Some wrinkling of
the liner may be evident and in no way affects the
structural strength of your pool. You can continue
to work out the wrinkles as needed by pulling
gently on the liner or by using a broom.
9