苏
州
特
鲁
利
电
子
材
料
有
限
公
司
Suzhou Trojan Industry Material Co.
，
Ltd
Building A,No.53#, Xinze Road,Singapore Industry Park,Suzhou,Jiangsu Province,
China.
Tel: 0512-67580617 Fax: 0512-67508229
13
off. The following situations are not available for the use of "Auto Detect whether cut-off".
2.1
）
As shown in the right pic, there are more than one
discontinuous sections on the cutting route.
2.2
）
Feed rate is slow and current value fluctuates little.
Note: The current setting should satisfy In < IL < IH.
Otherwise, the setting will unsuccessful.
3. Pulse- cutting: setting forward cutting time (Tf) and cutting backward speed (Vb). When
the current is more than IH, Tf starts to count and when time ends, the sample move
backward at speed Vb until the current value falls back to less than IH. If the setting value
of IH is high then it will takes less time to complete the sectioning. But the frequency of the
reciprocating cutting will decrease. If the setting value of IH is low then it will take a long
time to complete the sectioning, therefore the frequency of the reciprocating cutting will
increase. Different with the traditional pulse cutting algorithm. The pulse cutting mode of
Beta-300Pro only returns the tool under the condition of current overload, which greatly
reduces the number of reciprocating and improves the cutting efficiency.
Overload Protection:
4.1
）
Current overload: In any case, if the current exceeds the maximum setting value, it
will be returned back or reduce the feed rate.
4.2
）
Pressure Overload: Y-axis and Z-axis collide due to incorrect setting. When abnormal
pressure will detected by the system, the movement of Y-axis and Z-axis will stop moving
and the message will prompted on the interface.
5. Automatic find origin: Before cutting process, the cutting wheel does not rotate and the
feed process begins. When the cutting wheel touches the sample, it feeds in the opposite
direction, there is a small distance between the cutting wheel and the sample. The system
records the position at this time as the origin position of cutting process and then the cutting
process is executed according to the set parameters.
切割方向
（
Feeding Direction
）
切割片
（
Cutting Wheel
）
工件
（
Sample
）
截面
1
（
Section-1
）
截面
2
（
Section-2
）
