Trojan ENDURO 320, Care Instructions And Assembly Manual

10167-11

5. COMPUTER FUNCTIONS

QUICK START

1. Simply start pedaling and away you go!
2. The value of time, distance and calories will start counting upwards.
3. Adjust the resistance level with the large dial control knob.

OPERATIONAL PROCEDURES

POWER ON  : 

Start pedaling or push the MODE button.

POWER OFF : 

Automatically shuts off after four minutes of inactivity.

MODE BUTTON : Press to select the display functions, SCAN, TIME, SPEED, DISTANCE, CALORIES 

and HEART RATE.  Press and hold for three seconds to reset all functions to zero.

OPERATIONAL INSTRUCTIONS

SCAN : 

Automatically scans each function, TIME, SPEED, DISTANCE, CALORIES, and HEART RATE , in sequence and  

changes every four seconds. Press and release the MODE button until SCAN appears on the display.

TIME : 

Displays the time elapsed from one second up to 99:59 minutes.

SPEED : 

Displays the current speed from zero to 999.9 KM per hour.

DISTANCE :   

Displays the distance covered from zero to 99.99 KM.

CALORIES :   

Displays the calorie consumption from zero to 999.9 kcal.

The calories readout is an estimate for an average user. It should only be used as a comparison between  

workouts on this unit.

HEART RATE : 

Display your heart rate in beats per minute. To display heart rate, select the heart rate mode and grasp the  

pulse sensors on the handlebars, one in each hand. The heart symbol will begin flashing when the computer  

senses your heart rate. Your heart rate will be displayed approximately five seconds after the heart icon is 

displayed. If you do not place your hands correctly and 60 seconds passes without a heart rate reading, the 

computer will turn off the heart rate circuit. If this occurs, press the MODE button to restart, place your hands  

back on the pulse sensors correctly, and the heart rate readout will appear.

Note

:  The computer will shut off automatically after four minutes of inactivity. All function values will be kept. Push the MODE button 

and hold it down for three seconds to reset all functions to zero.

BATTERY INSTALLATION:

1.  Disconnect the computer from the equipment.
2.  Open the battery door on the back of the computer.
3.  The computer operates with 2 AA batteries.

Note

:

1.  Do not mix a new battery with an old battery.
2.  Use the same type of battery. Do not mix an alkaline battery with another type of battery.
3.  Rechargeable batteries are not recommended.