Trojan ENDURO 320, Care Instructions And Assembly Manual

10167-9

ASSEMBLY STEPS

STEP 3.  

•  Remove the 4 pre-assembled Allen Head Bolts (26), 

4 Spring Washers (27) and 4 Curved Washers (28) 
from front post mounting tube of Main Frame (19). 

•  Slide the Front Post Decoration Cover (30) onto the 

Front Post (15). 

•  Connect the Sensor Wire (25) to the socket of the 

Middle Section Sensor Wire (9).

•  Connect the Lead Head of Middle Section Tension 

Cable (11) to the C bracket of the Lower Section 
Tension Cable (55) . Follow steps in figure A1-A4.

•  Slide Front Post (15) onto front post mounting tube 

of Main Frame (19) and secure, using 4 Allen Head 
Bolts (26), 4 Spring Washers (27) and 4 Curved 
Washers (28). 

•  Pull the Front Post Decoration Cover (30) to the 

bottom of Front Post (15).

STEP 4

•  Attach the middle thread of Handlebar (2), which 
  includes 2 Hand Pulses (5), to the welded metal 

clamp of Upper Front Post (15) and secure with 
Sleeve (12) Clamp Decortion Cover (71) and Wing 
Knob (14).

Caution

: Ensure that cables are not damaged 

during assembly or when tightening screws

Caution

: Ensure that cables are not damaged 

during assembly or when tightening screws