Trojan MARATHON 200, Care Instructions And Assembly Manual

1559-9

7. MAINTENANCE

RUNNING BELT NOT CENTERED

• If the running belt is not centered on the tail roller and it’s either  
  too far left or right, please turn off the treadmill first. 
• Use 6mm Allen Wrench shaped wrench to loosen bolts within    
  rear adjusting boxes. 
• If the running belt is tracking to the left, adjust belt to track to the  
  right. Tighten the left tail roller Allen screw by turning quarter
  clockwise. The same procedure applies if the belt is pulling right   
  i.e. tighten right tail roller. Power on the treadmill after 
  the adjustment. If it has no obvious effect, just repeat the steps    
 above. 
• Do not use the treadmill until the running belt returns    
to the center position. Should tracking occur please use the  

  above mentioned steps to rectify the issue. 

• 

Please note: The running belt might not stay precisely in the  

  center, but might move slightly to either the right or left side. 
• When aligned properly the belt wont scratch the side rails. 

LUBRICATION

• It is strongly suggested that you follow the timetable below to 
  apply lubrication to the running deck. 
• Firstly use the 6mm wrench to loosen the bolts within the rear    
  adjusting boxes, pull up the running belt and evenly apply 
  lubrication on the center deck. 
• Then adjust the belt to the center of deck and following the  

  above step to tighten the belt. 
• Please run treadmill at low speed, after all bolts are secure, to    
  allow equal distribution of the lubricating oil.
• Please follow the above steps to lubricate the belt if you 
  experience any skid phenomena. 

LUBRICATION TIMETABLE

Speed    

Suggested Time 

1~6 km  

1 year 

6~12 km  

6 months 

12~16 km  

3 months