21
10375
MAINTENANCE
Reasonable cleaning/lubricating should be made to extend the life time of this unit. Performance is maximised
when the belt and mat are kept as clean as possible.
WARNING
The mat/deck friction may play a major role in the function and life of your treadmill and that is why we
recommend you constantly lubricate this friction point to prolong the serviceable life of your treadmill.
Failing to do this may void your warranty.
•
Unplug power cord before maintenance.
•
Stop treadmill before folding.
4.1 GENERAL CLEANING
•
Use a soft, damp cloth to wipe the edge of the belt and the area between the belt edge and frame. A
mild soap and water solution along with a nylon scrub brush will clean the top of the textured belt. This
task should be done once a month. Allow to dry before using.
•
On a monthly basis, vacuum underneath your treadmill to prevent dust building up. Once a year, you
should remove the black motor shield and vacuum out dirt that may have accumulated.
4.2 GENERAL CARE
•
Check parts for wear before use.
•
Always replace the mat if worn and any other defective parts.
•
If in doubt do not use the treadmill and contact our help line.
Take care to protect carpets and floor in case of leakages. This product is a machine that contains moving parts
which have been greased/lubricated and could leak out.
4.3 BELT/DECK/ROLLER LUBRICATION
You should apply the lubrication after approximately the first 40 hours of operation. We recommend
lubrication of the deck according to the following timetable:
•
Light use
(less than 3 hours per week) every 6 months.
•
Medium use
(3-5 hours a week) every 3 months.
•
Heavy use
(more than 5 hours per week) every 6-8 weeks.
See below procedures for lubricating:
1.
Use a soft, dry cloth to wipe the area between the belt and deck.
2.
Spread lubricant onto the inside surface of belt and deck evenly (make sure the machine is turned
off and power is disconnected).
3.
Periodically lubricate the front and rear rollers to keep them at the peak performance. If the treadmill
belt/deck/roller is kept reasonably clean it is possible to expect over 1200 hours before additional
re-lubing is necessary.
Summary of Contents for Marathon 320
