11
10390
ASSEMBLY STEPS
STEP 3: HANDLEBAR POST AND COVER
Remove 4 x M8 x 15 Bolts (12), 2 x Ø20 x Ø8 x 2.0
Washers (21) and 2 x Ø16 x Ø8 x 1.5 Washers (13)
from the Main Frame (1). Remove bolts with the S6
Allen Key provided.
Slide the Handlebar Post Cover (17) up to the
Handlebar Post (3).
Connect the Extension Sensor Wire II (18) from the
Main Frame (1), to the Extension Sensor Wire I (15),
from the Handlebar Post (3).
Insert the Handlebar Post (3) into the tube of the
Main Frame (1) and secure with 4 x M8 x 15 Bolts (12),
2 x Ø16 x Ø8 x 1.5 Washers (13) and 2 x Ø20 x Ø8 x
2.0 Washers (21) that were removed. Tighten bolts
with the S6 Allen Key provided.
Slide the Handlebar Post Cover (17) down to the
Handlebar Post (3).
STEP 3
STEP 4: SEAT POST, SLIDING TUBE COVER,
CUSHION, AND SLIDING TUBE
INSTALLATION
Remove 3 x M8 Nylon Nuts (25) and 3 x Ø16 x Ø8 x
1.5 Washers (37) from underneath the
Seat Cushion (38).
Attach the Seat Cushion (38) to the triangle plate
of Seat Sliding Tube (5) with 3 x M8 Nylon Nuts (25)
and Ø16 x Ø8 x 1.5 Washers (37) that were removed.
Remove 1 x Ø10 x Ø20 x 2 Washer (33) and Seat
Adjustment Knob M10 (32) from underneath the
Seat Sliding Tube (5) and then attach the Seat
Sliding Tube (5) to the Seat Post (4) with 1 x Ø10
x Ø20 x 2 Washer (33) and Seat Adjustment Knob
M10 (32) that were removed.
Remove 2 x Screw ST4.2 x 20 (31) from the Seat
Post (4) and then attach the Seat Sliding
Tube Cover (34) onto the Seat Post (4) with
2 x Screw ST4.2 x 20 (31) that were removed.
STEP 4
Summary of Contents for POWER 500
Page 9: ...9 10390 EXPLODEDDRAWING...
Page 32: ...32 10390 NOTES...
