Trojan PURSUIT 360, User Manual

13

10388

ASSEMBLY STEPS

STEP 6:  SEAT CUSHION INSTALLATION

• 

Remove three 

Ф

8 x 

Ф

16 Flat Washers (37) and three M8 Nylon Nuts (42) from underside of the Seat 

Cushion (27). Guide the bolts on the underside of the Seat Cushion (27), through the holes on top of the 
Seat Slider (65), attach with three removed 

Ф

8 x 

Ф

16 Flat Washers (37) and three M8 Nylon Nuts (42). 

Tighten nuts with Multi Hex Tool with Phillips Screwdriver provided.

ADJUSTING THE SEAT BACK AND FORTH

• 

Turn the M10 Knob (68) in a counterclockwise direction to release the Seat Slider (65) and then slide the 
Seat Slider (65) back or forth slightly to the desired hole for the suitable position. Lock the Seat Slider (65) in 
place by tightening M10 Knob (68) in a clockwise direction.

STEP 7:  SEAT POST INSTALLATION

• 

Insert the Seat Post (25) into the Seat Post Plastic Bushing on the tube of the Main Frame (1) and then 
attach the M16 Seat Height Adjustment Knob (8) onto the tube of the Main Frame (1) by turning it in a 
clockwise direction to lock the Seat Post (25) in the suitable position.   

ADJUSTING THE SEAT HEIGHT

• 

Turn the M16 Seat Height Adjustment Knob (8) in a counterclockwise direction to release the Seat Post (25) 
and then slide the Seat Post (25) up or down slightly to the desired hole for the suitable position.

• 

Lock the Seat Post (25) in place by tightening the M16 Seat Height Adjustment Knob (8) in a

        clockwise direction.

NOTE:

 When adjusting the height of Seat Post, make sure the Seat Post Plastic Bushing does not exceed

            the mark line on the Seat Post.

TOOL:

Multi Hex Tool with Phillips 
Screwdriver (S13, S14, S15)

STEP 6 & 7