Trojan SPIN 100, User Manual

14

SPIN100-SB

FUNCTIONS AND OPERATIONS:

POWER ON:          

 If the button is pushed, the unit will turn on and display the parameters of

                                   the last exercise.

SCAN:

 Push the button and the unit will display 5 parameters one by one. Push the mode key

                                    until the arrow signal shows on the bottom right hand side. The unit will scan through
                                    Time, Speed, Distance, Calories and Pulse each for 4 seconds. 

ODOMETER:           

Push the mode key again and the scan will stop and the “SCAN” signal will disappear.

                                    If you push the button until the arrow points to “ODO”, the display will show the
                                    Odometer on the meter. The reading of the odometer will be reset to zero after
                                    replacing the batteries.

SPEED:

Push the mode key until the arrow points to “SPD” to display the speed value.

                                   Unit: km/h.

TIME:

Push the mode key until the arrow points to “Time” to display the exercise time.

                                    If the bike stops moving, the unit will stop counting time also.

DISTANCE:

Push the mode key until the arrow points to “Dist” to display the distance value.

                                    Unit: km.

CALORIES:

Push the mode key until the arrow points to “CAL” to display the calories value.

                                    Unit: K Cal.

RESET:                   

 Push the mode key for 3 seconds until the unit shows a zero value.

AUTO OFF:            

 The unit will automatically turn off if there is no movement for 4 minutes.

CONSOLE FUNCTIONS