14
ASSEMBLY STEPS
ADJUSTING THE HANDLEBAR
It is important that the Handlebar (8) and Seat (66) are both set to the correct height of your body. To adjust the
Handlebar (8) height, loosen and pull the Adjustment Knob (Ø50 x 20 x M8 x 15) (73), then slide the Handlebar
Post (4) up or down to the desired height. Once adjusted re-insert and tighten the Adjustment
Knob (M16 X 1.5 X 22 X Ø56) (62) to secure the Handlebar Post (4) in place.
EMERGENCY BRAKE
During use, users can stop the bike completely by pushing down on the Tension Knob (Ø52 X 33 X M10 X 20) (63).
Pushing down on the Tension Knob (Ø52 X 33 X M10 X 20) (63) will enforce the brake and bring the bike to an
immediate stop.
ADJUSTING THE BALANCE
In order to achieve a smooth and comfortable ride, you must ensure that the stability of the bike is secured. If
you notice that the bike is unbalanced during use, you should adjust the Foot Leveler (Ø45 X 10 X M8 X 20) (76)
located beneath the Front and Rear Stabilisers of the bike.
To do so, use Spanner (S = 13, 14, 15) (25) to loosen 2 Nuts by turning them clockwise. With the nut loosened,
rotate the Foot Leveler (Ø45 X 10 X M8 X 20) (76) until it sits level with the surface that the bike is on. When you
have finished adjusting the Foot Leveler (Ø45 X 10 X M8 X 20) (76), use Spanner (S = 13, 14, 15) (25) to re-tighten
the 2 Nuts by turning them counterclockwise. If required, repeat this process to adjust the remaining Foot
Leveler (Ø45 X 10 X M8 X 20) (76).
#20M01T007 SPIN 120 UM.indd 14
28/01/2020 08:39