Tronic KH 3002, Operating Instructions Manual

- 4 -

• Do not operate the Energy Station in the im-

mediate vicinity of sources of heat, such as an oven,
hot air blowers (in a vehicle: close to heating
vents) and similar appliances! Heat effects could
lead to the equipment overheating and to the
melting of plastic parts, whereby the Energy 
Station could be irreparably damaged!

If it is overheated, the Energy Station could 
be irreparably damaged and the risk of 
a fire exists!

• This appliance must not be placed in the im-

mediate vicinity of flammable materials, 
for example curtains, inflammable liquids etc.

• Do not place any open sources of fire, 

like candles, on the appliance.

Injury hazard!

• Keep children away from the connecting cable

and the appliance. Children frequently under-
estimate the dangers of electrical appliances.

• Ensure that the appliance stands with a safe and

secure positioning.

• Do not operate the appliance if it has sustained

a fall or is damaged. Arrange for the appliance
to be checked and, if necessary, repaired by
qualified technicians.

Start-up

The Energy Station is supplied with a low-level pre-
charged battery. Prior to initial usage it must therefore
be charged.

Attention! 

The battery can lose considerable capacity should
you use the Energy Station without fully charging it
beforehand!

• Before taking the appliance into use, check to

ensure that the Energy Station, the connection
cables 

and the power supply unit 

are in 

a defect-free condition. 

Danger!

NEVER use a damaged connection cable. Risk of
short circuit!

Charging with the mains power plug

Attention: Explosive Gas

Avoid flames and sparks. During charging, ensure
that there is sufficient ventilation.

1. Insert the appliance plug of the power supply

unit 

in the charging socket DC-INPUT 

w

at

the back of the appliance.

2. Connect the power supply unit 

to a mains 

power socket. The mains voltage must conform
with the specifications on the ratings plate of the
power supply unit.

3. Place the main switch 

2

at the front of the appli-

ance to the “CHA” position. The Energy Station is
now being charged.

4. While the Energy Station is charging, the red LED

“On” 

6

in the field CHARGE will be illuminated.

5. When the battery is nearly fully charged, the

green LED “Full” 

6

will start to be faintly illumi-

nated. As soon as it is fully illuminated you can
remove the power supply unit 

. The red LED

"On" 

6

continues to glow until you place the

main switch 

2

in the position "OFF".

Charging with the vehicle adapter

You can also charge the Energy Station by con-
necting the supplied vehicle adapter 

to the 

12V on-board voltage system of a motor vehicle or
sports boat:
1. First insert the appliance plug of the 12V vehicle

adapter 

in the charging socket 

w

at the rear

of the appliance.