Tronic KH 3002, Operating Instructions Manual

- 5 -

2. Then insert the 12 V plug of the vehicle adapter

in the 12-V plug resp. in the cigar lighter of

the vehicle.

Danger!

The above sequence is important, as it avoids a short
circuit due to inadvertent contact of the appliance
plug with the vehicle chassis.

3. Place the main switch 

2

at the front of the appli-

ance to the “CHA” position. The Energy Station is
now being charged.

4. While the Energy Station is charging, the red LED

“On” 

6

in the field CHARGE will be illuminated.

5. When the battery is nearly fully charged, the

green LED “Full” 

6

will start to be faintly illumi-

nated. As soon as it is fully illuminated you can
remove the vehicle adapter 

. The red LED "On"

6

continues to glow until you place the main

switch 

2

in the position "OFF".

Notice! 

A charging process is only established if the charging
voltage is higher than that of the battery. With a sta-
tionary vehicle this is frequently not the case. Gene-
rally speaking, charging is therefore only possible
with the engine running.

Power supply over the low 
voltage socket (max. 1 A)

Caution!

Before performing any connections, always check
to ensure that both the appliance to be supplied
and the Energy Station are switched off. Place the
main switch 

2

in the “OFF” position (centre position).

In this way you can avoid damage through connec-
tion faults.

Carrying out connections

A total of 5 low voltage connection sockets 

4

, 

from 3 - 12 V, are available for the supply of power 
to appliances with a maximum power consumption 
of 1 A:
1. Insert the adapter cable 

in the low voltage

connection socket 

4

corresponding to the voltage

required for the appliance to be supplied. 

2. Select the suitable adapter connector 

for the

input to the appliance being supplied.

Caution!

Ensure that “Positive” and “Negative” have not
been switched. Otherwise your appliance could 
be damaged!

3. Connect the selected adapter plug 

and the

adapter cable 

together so that positive and

negative correspond to the markings on the 
sockets of your appliance.

Polarity of the adapter plug:

• Should the adapter plugs 

be connected with

positive to positive and negative to negative on
the adapter cable 

, then on the adapter plugs 

positive is above resp. inside and negative is 
below resp. outside.