feeding pipe
3. Place the glass fiber board on the aluminum substrate, align the
sides, and fasten with 4 clamps, as shown in the figure.
mainframe 1pcs
Assembly material specification and quantity:
Step 13: assemble decorative strip and feeding pipe, glass fiber board
2. Cut the decorative strip to the appropriate length and press it
into the aluminum profile groove, as shown in the figure.
1. Pull the feeding tube into the air nozzle hole of the feeding
component, press down the plastic outer ring of the air nozzle,
insert the feeding tube, loosen the plastic ring and jam the feeding
tube, as shown in the figure.Make sure the material tube is
jammed.Then put the other end of the feeding tube into the air
nozzle of the printing head assembly and confirm that the feeding
tube is tightened.
decorative strip 1roll
feeding pipeΦ4 2pcs
glass fiber board 1pcs
clamp 4pcs
Summary of Contents for X5S 2E
Page 16: ...Wiring diagram of main board ...