3.2 click the icon of preheating, as shown in the figure, set the heating temperature of the machine extrusion head and the hot bed, heat the icon
hot bed and heat the icon extrusion head, and click the icon in the right and left direction to adjust the setting temperature heating.Use the heating
function when replacing consumables.
3.3 click the icon of loading and unloading consumables to indicate preheating.Remove the consumables to warm up before pulling them out.Set the
heating temperature, the temperature reached, click the icon to return the material.When installing the filaments, make the filaments go straight
out into the hole of the filament run-out detector and press down the feeder's pressing block, as shown in the figure. Pass the filaments through the
feeder to the filaments pipe and then click the icon to send the filaments to the nozzle.Click the icon to stop.
3.4.1 click the leveling icon and enter the leveling menu. There are 3 options: auto leveling, manual leveling and cancel.Click cancel to return.