8-1. ON/OFF - Fan
8-3. Reverse switch
8-2. Fan Speed
8-4. Timer (1hr/4hrs/8hrs)
8-5. Indicator
8-6. 12V battery (23AE/A23)
included, install in back
(
1
-Low Speed
5
-High Speed
)
8. OPERATIONAL INSTRUCTION
8-1. Press button to turn the fan ON/OFF.
Warning: DO NOT PRESS THE BUTTON
FOR MORE THAN 4 SECONDS TO AVOID
FACTORY RESET AND THE LOSS OF
PRE-PAIRED PROGRAMING OF RECEIVER
AND TRANSMITTER!
Note: On every startup, the fan will move
forward & backward for 2~3 seconds.
8-2. Fan Speed
:
1
-Low Speed
5
-High Speed
8-3. Reverse switch
8-4. Timer (1hr/4hrs/8hrs)
8-5. Indicator
8-6. 12V battery (23AE/A23)
included, install in back
8-7. Light On/Off/Dimmer (#600 sold separately)
Short press for Light ON/OFF
Hold the button for dimming the light
NOTE: Make sure the DIP switch is on
dimming position. (See 7-2 in Page 6)
All the button pressed will have a Beep sound
and the red indicator light will turn on.
Note: The remote retains the last settings (fan speed and light dimming level)
in memory. When turn on again, the fan will be on the same speed, and the light
will be at the same brightness.
8
-
7. Light function
#600
Light Kit
(sold separately)
OPTIONAL LIGHT AVAILABLE
TROUBLESHOOTING
In the event the fan does not operate properly, please perform the following steps.
8-8. Lower the canopy and check that all wires are connected properly.
8-9. Perform the remote Pairing Process at step 9-1 on P8.
From Remote
From House
(AC-N)
(AC-L)
White
Black
From Fan
Black
White
Black
White
Gray
Black
White
Gray
(
For motor
)
(
For motor
)
(
For motor
)
Green
( house ground wire )
Green
Green
( from Hanger Ball )
( from mounting bracket )
Blue
Blue
(
For Light Kit
)
Orange
Orange
(
For Light Kit
)
(
For motor
)
(
For motor
)
(
For motor
)
(
For Light Kit
)
(
For Light Kit
)
JST connector
Integrated type:
For Ion / Troposair
P7
