6
EN
humidifier B 3 E / B 4 E
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Adapter
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Only put up the device in an upright, stable position on firm
ground.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that there are no moisture-sensitive objects in
the immediate vicinity of the mist nozzle, since water may
condense near the mist nozzle.
Filling the water tank
The water tank (
4
) should be filled with clear drinking water
before first use.
Note
Fill the device with clear drinking water only. The water
temperature must not exceed 40 °C.
Scented oil or other additives can damage the plastics
and the nebulizer membrane.
Info
If possible, change the water every 3 days to prevent
bacterial growth.
Info
The
low water level
LED (
20
) flashes permanently
when the water level in the water tank (
4
) is too low.
Info
The
low water level
LED (
20
) flashes three times in
succession when the water tank (
4
) is empty. The dry-
run protection is activated.
1. Open the lid with air outlet (
1
).
1
4
2. Fill clear drinking water (maximally 40 °C) up to the
MAX
indication into the water tank (
4
).
3. Insert the SecoSan
®
Stick (optional accessory) (
15
) into the
water tank (
4
).
4. Now close the lid with air outlet (
1
). Ensure that the lid is
aligned correctly.
1
4
15
