6
EN
multimeter BE47
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device use a suitable bag to protect it from
external influences.
Storage
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
protected from dust and direct sunlight
•
with a cover to protect it from invasive dust if necessary
•
The storage temperature is the same as the range given in
the Technical data chapter.
•
Remove the batteries from the device.
Operation
Inserting the battery
Insert the battery before first use.
Danger
Disconnect the measuring probes from the device
before opening the battery compartment.
Note
Make sure that the surface of the device is dry and the
device is switched off.
1. Remove the protective cover (1) from the device.
2. Loosen the screw at the battery compartment (5).
3. Open the battery compartment.
4. Connect the battery to the battery clip with correct polarity.
5. Insert the battery with the battery clip into the battery
compartment.
6. Close the battery compartment and retighten the screw.
7. Place the device back into the protective cover.
Attaching the warning sign
Prior to initial start-up, check whether the warning sign at the
rear of the device is in your local language, if not, paste the
proper one over it. A warning sign in your native language is
supplied along with the device. Please proceed as follows to
attach the warning sign to the rear of the device:
1. Remove the label in your local language from the supplied
film.
2. Stick the label on the intended position at the rear of the
device.
