EN
17
digital true RMS multimeter BE52
Submenu settings
In the submenu
SETTINGS
you can adjust different settings, e.g.
changing the menu language.
Note
The various sensors have slightly different setting
options.
Example: Submenu
SETTINGS
:
Sensors
Measurements
Reports
Customers
Settings
Settings
Language
English
Help
[Temperature °F]
Maintenance and repair
Battery change
Info
In case of a low battery the displayed values may be
inaccurate or incorrect! If so, stop using the measuring
device and exchange the batteries immediately.
A battery change is required when the battery status indication
displays an empty battery symbol, when incorrect measured
values are displayed or when the device can no longer be
switched on (see chapter Inserting the batteries).
Fuse replacement
Caution
Switch the device off and remove the measuring tips
from the measuring sockets before opening the device!
Internal fuses may only ever be replaced with fuses of
the same type, never with one of a higher amperage or
with a provisional solution! Otherwise the
consequences include the risk of accidents, the
destruction of the device and the loss of warranty.
Note
Only replace fuses of the same type!
1. Fold the stand at the rear of the device up.
2. Loosen the screw of the fuse compartment and remove the
fuse compartment cover.
3. Remove the defective fuse.
4. Insert a new fuse:
- µA/mA range: 500 mA / 600 V
- 10 A range: 10 A / 600 V
5. Attach the cover and secure it by tightening the screw.
6. Fold back the stand.
Cleaning
Clean the device with a soft, damp and lint-free cloth. Make
sure that no moisture enters the housing. Do not use any
sprays, solvents, alcohol-based cleaning agents or abrasive
cleaners, but only clean water to moisten the cloth.
Repair
Do not modify the device or install any spare parts. For repairs
or device testing, contact the manufacturer.
