EN
8
Operating manual – 3-in-1 multi-function sander PMSS 10-200
Technical data
Parameter
Value
Model
PMSS 10-200
Mains connection
1/N/PE ~ 230 V / 50 Hz
Power consumption
200 W
Nominal oscillation rate
14,000 – 24,000 opm
Idle speed
7,000 – 12,000 rpm
Orbit diameter
2 mm
Grinding surface
Delta sanding plate
Random orbital sanding plate
Orbital sanding plate
108 cm
2
116 cm
2
165 cm
2
Cable length
3 m
Protection class
II /
Weight
1.5 kg
Vibration information according to EN 60745
Vibration emission value main
handle a
h
11.5 m/s²
Uncertainty K
1.5 m/s²
Sound values according to EN 60745
Sound pressure level L
pA
76 dB(A)
Sound power L
WA
87 dB(A)
Uncertainty K
3 dB
Wear hearing protection.
Excessive noise can lead to hearing loss.
Information on noise and vibration:
•
The vibration level specified in these instructions was
determined by means of a measuring method standardized
in EN 60745 and can be used for a device comparison. The
specified vibration emission value may also be used for a
preliminary assessment of the exposure.
Caution
Vibration emissions can cause a health hazard if the
device is used for an extended period of time or if it is
not properly handled and maintained.
•
The vibration level will change depending on the
application of the power tool and may in some cases differ
from the value specified in these instructions. The vibration
load may be underestimated if the power tool is used
regularly in such a way. For a precise estimation of the
vibration load during a certain work period, it is also
important to consider the periods during which the device
is switched off, or is running but not actually employed.
This can reduce the vibration load over the entire work
period significantly.
