EN
3
radiant heater IR 2010 S
•
Do not use the device in aggressive atmosphere.
•
Let the device dry out after a wet clean. Do not operate it
when wet.
•
Do not use the device with wet or damp hands.
•
Do not expose the device to directly squirting water.
•
Never insert any objects or limbs into the device.
•
Do not use the device as source of ignition.
•
Do not cover the device during operation.
•
This appliance is not a toy. Keep away from children and
animals. Do not leave the device unattended during
operation.
•
Check accessories and connection parts for possible
damage prior to every use of the device. Do not use any
defective devices or device parts.
•
Ensure that all electric cables outside of the device are
protected from damage (e.g. caused by animals). Never
use the device if electric cables or the power connection
are damaged!
•
The mains connection must correspond to the
specifications in the Technical annex.
•
Insert the mains plug into a properly fused mains socket.
•
Observe the device's power input, cable length and
intended use when selecting extensions to the power
cable. Completely unroll extension cables. Avoid electrical
overload.
•
Before carrying out maintenance, care or repair work on
the device, remove the mains plug from the mains socket.
Hold onto the mains plug while doing so.
•
Switch the device off and disconnect the power cable from
the mains socket when the device is not in use.
•
Do not under any circumstances use the device if you
detect damages on the mains plug or power cable.
If the power cable is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Defective power cables pose a serious health risk!
•
When installing the device, observe the minimum
distances from walls and other objects as well as the
storage and operating conditions according to the technical
data (chapter Technical annex).
•
Keep a safety distance of at least 1 m between the
device's radiator side and all combustible materials such
as textiles, curtains, beds and sofas.
•
Allow the device to cool down before transport and/or
maintenance work.
•
The device must not be installed directly beneath a socket.
•
The device must be set up in a way that the switches and
controllers cannot be touched by a person in a bathtub or
shower.
•
The device must not be used with a programming switch,
timer, separate remote control system or similar
equipment that switches the device on automatically, as
this could cause a fire hazard if the heater is covered or
positioned incorrectly.
•
Do not use the device if it has been dropped or if it shows
visible signs of damage.
Intended use
Use the device for heating surfaces in roofed outdoor areas
protected from weather effects.
Intended use comprises:
•
heating surfaces
– in storage facilities,
– in construction areas,
– in containers,
– in the catering trade,
– at trade fairs and events,
– in roofed outdoor areas (e.g. covered terraces).
Foreseeable misuse
•
The device is not intended for industrial use.
•
Do not place any objects, e.g. clothing, on the device.
•
Do not use the device for heating in vehicles.
•
Do not use this device in the vicinity of fuel, solvents,
varnishes or other easily inflammable vapours or in rooms
where these substances are stored.
•
The device may not be used as a heating device for
babies / children or animals.
•
Do not install the heating device in immediate proximity to
swimming pools!
•
The device may not be exposed to moisture or weather
effects (rain, sunlight).
•
The device must not be mounted to the ceiling.
•
Any use other than the intended use is regarded as a
reasonably foreseeable misuse.
Any unauthorised changes, modifications or alterations to the
device are forbidden.
Personnel qualifications
People who use this device must:
•
be aware of the dangers that occur when working with
electric devices in damp areas.
•
have read and understood the operating manual, especially
the Safety chapter.
Maintenance tasks which require the housing to be opened
must only be carried out by specialist electrical companies or by
Trotec.
