EN
9
infrared radiant heater IRD 1200 / IRD 1800 / IRD 2400 / IRD 3200
1. Measure the distance between the holders on the device
and use this value for the distance between the drill holes.
2. Mark the drill holes on the wall / ceiling. Please note the
mounting brackets must be fastened
vertically
.
3. Drill the holes into the wall / ceiling at the marked
positions.
4. Insert suitable wall plugs into the drill holes.
5. Screw the mounting brackets to the wall / ceiling.
6. Check the mounting brackets for tight fit.
7. The device can be installed at an inclination angle
of 0°, 15°, 30° or 45°.
Please note that the inclination angle must be 15°, 30°
or 45° for wall mounting and 0°, 15° or 30° for ceiling
mounting.
0°
30°
45°
15°
