EN
9
monobloc air conditioner without external unit PAC-W 2600 SH
Note
After drilling the two holes, make sure that the intake
of the outside air and the return of the air to the outside
are not obstructed by leafy plants, facade cladding,
window shutters or similar.
The following tools are required for assembly:
•
Spirit level
•
Drill
•
Tape measure
•
Cutter knife
•
Pen
•
8 mm Masonry drill bit
•
20 mm Masonry drill bit
•
180 mm Core drill bit
Assemble the device as follows:
Select screw and wall plug sizes suitable for the weight of the
device (see technical data) and the structure of the wall.
1. Align the supplied wall template on the wall and stick it in
place.
2. Drill a hole for the condensate outlet. Make sure that the
bore runs downwards at an angle of at least 5° so that the
condensate water can drain off easily.
3. Drill the holes for the exhaust air and fresh air supply using
the 20 mm masonry drill bit and the 180 mm core drill bit.
Warning
Before and during assembly, ensure that no persons
are endangered by the material removed towards the
outside. The last part of the installation must be carried
out with the utmost care and with little pressure so that
the exterior plaster is not damaged.
4. Use the template to mark the positions of the screws for
the suspension rail.
5. Drill the holes with the 8 mm masonry drill bit so that they
are suitable for the wall plugs supplied.
6. Mount the support rail to the wall and align it with the spirit
level.
7. Check the attachment of the suspension rail and make
sure that there is no risk of the device falling down.
8. Roll the plastic film sheets into a tube and feed them
through the large wall holes until they are positioned flush
with the interior wall.
9. Neatly cut off any excess plastic film sheets on the outer
wall with a sharp knife.
10. Insert the inner fixing ring of the ventilation cover on the
inside of the ventilation opening.
11. Then fold the outer ventilation cover in half.
