EN
15
bench grinding machine PBGS 10-120
Using a flexible shaft
Note
Never actuate the spindle lock (
42
) while the tool is
running! This may damage the tool.
Info
Use the flexible shaft for tasks requiring fine and
precise guidance of the tool.
Warning of hot surface
Ensure that the flexible shaft does not form a loop or
become kinked during operation. There is a risk of the
shaft becoming hot and melting with the hose.
Do not touch the handle if it became hot. Risk of burns.
ü
The device is switched off and the mains plug is
disconnected.
1. Place the lock nut (
3
) of the flexible shaft onto the
connection thread (
2
) on the device and ensure that the
square inner axis (
41
) of the flexible shaft engages with the
holding fixture of the flexible shaft (
49
).
2. Tighten the lock nut (
3
) in counter-clockwise direction.
3
2
41
49
Tool change
Wear protective gloves
Wear appropriate protective gloves when inserting or
exchanging tools.
Proceed as follows to clamp a tool on the handle (
35
) of the
flexible shaft:
ü
The device is switched off and the mains plug is
disconnected.
1. In order to block the spindle, pull back the spindle lock (
42
)
on the handle (
35
) and hold the position.
2. Loosen the clamping nut (
43
) by means of the wrench (
7
)
by turning it in counter-clockwise direction.
3. Remove the tool from the tool holder (
34
), if any.
42
7
35
43
34
4. Insert the tool required into the tool holder (
34
).
5. Tighten the clamping nut (
43
) in clockwise direction using
the wrench (
7
).
6. Let go of the spindle lock (
42
).
7. Check the tool for tight fit.
