18
EN
cordless belt sander PBSS 10-20V
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
If required, allow the device to cool down.
•
Remove the battery from the device (see Start-up chapter).
•
Remove the tool from the device (see Start-up chapter).
•
If attached, disconnect the dust extraction system from the
device.
•
If attached, disconnect the dust bag from the device.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Designation
Article number
Multiflex 20V 2.0 Ah spare battery
6.200.000.303
Multiflex 20V 4.0 Ah spare battery
6.200.000.320
Belt sanding paper set, 10-piece
6.235.001.101
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
•
Check whether the battery is correctly connected to the
quick charger.
Slide the battery into the quick charger in a way that the
battery terminals engage in the quick charger. The battery
must lock in place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
Check the fuse (home).
•
Check the quick charger for damages. Should the quick
charger be damaged, stop using it. Contact the Trotec
customer service.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery might be defective and have to be replaced.
Only use batteries of the same type.
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check whether the battery is correctly connected to the
device.
Slide the battery onto the device in a way that the battery
terminals engage. The battery must lock in place in the
device.
•
Check the battery terminals for dirt. Remove any dirt.
Info
Wait for at least 10 minutes before switching the
device back on.
The abrasive belt does not move although the motor is
running:
•
Make sure that the abrasive belt does not grind into the
housing. Adjust the belt run if required, see chapter
Adjusting the belt run.
•
Make sure that there is no workpiece debris blocking the
drive. Remove the blockages, if any.
•
Check whether you are using an abrasive belt that is
suitable for this device.
The motor slows down:
•
Check whether the device is overloaded by the workpiece.
