background image

2

EN

compressor PCPS 10-1100

Table of contents

Notes regarding the instructions .......................................... 2

Safety ..................................................................................... 3

Information about the device................................................ 7

Transport and storage........................................................... 8

Start-up.................................................................................. 9

Operation ............................................................................. 11

Errors and faults.................................................................. 13

Maintenance ........................................................................ 14

Disposal ............................................................................... 14

Declaration of conformity ................................................... 15

Notes regarding the instructions

Symbols

Warning of electrical voltage

This symbol indicates dangers to the life and health of
persons due to electrical voltage.

Warning of hot surface

This symbol indicates dangers to the life and health of
persons due to hot surface.

Warning

This signal word indicates a hazard with an average
risk level which, if not avoided, can result in serious
injury or death.

Caution

This signal word indicates a hazard with a low risk
level which, if not avoided, can result in minor or
moderate injury.

Note

This signal word indicates important information 
(e.g. material damage), but does not indicate hazards.

Info

Information marked with this symbol helps you to carry
out your tasks quickly and safely.

Follow the manual

Information marked with this symbol indicates that the
instructions must be observed.

Wear hearing protection

Information marked with this symbol indicates that you
should wear hearing protection.

Wear safety glasses

Information marked with this symbol indicates that you
should wear eye protection.

Wear a protective mask

Information marked with this symbol indicates that you
should wear a protective mask.

Wear protective gloves

Information marked with this symbol indicates that you
should wear protective gloves.

Other symbols used on the device:

Do not leave switched on

Information marked with this symbol indicates that the
device must be switched off immediately after use.

Compressor may start up without warning

Information marked with this symbol indicates that the
device may start up without warning when it is
switched on.

For indoor use only

Information marked with this symbol indicates that the
device was not designed for outdoor use.

Indication of the sound power level L

WA

 

in dB

Information marked with this symbol indicates the
sound power level L

WA

 in dB.

Device conforms to protection class II

Information marked with this symbol indicates that the
device conforms to protection class II.

Device may start up without warning

This symbol indicates that the device may start up
without warning when it is switched on.

Device may start up without warning

This symbol indicates that there is a danger to the life
and health of persons when using the tool in the rain or
during a thunderstorm.

You can download the current version of the instructions via the
following link:

PCPS 10-1100

https://hub.trotec.com/?id=41525

Summary of Contents for PCPC 10-1100

















Reviews: