EN
14
Operating manual – PCPS 10-16V / PCPS 11-16V
The device is running, but there is no apparent inflation/
deflation:
•
Check the connections for tightness. Air might be escaping
at the valve of the inflatable object.
The device becomes hot:
Notice
The device is not suitable for continuous operation. To
prevent overheating, the device must not be used non-
stop for more than 10 minutes (
PCPS 10-16V
) or
20 minutes (
PCPS 11-16V
).
Should the device be overheating nonetheless, remove
the battery.
Allow the device to cool down sufficiently before
switching it back on.
•
Check whether the device is suitable for the tasks to be
carried out.
•
Keep the venting slots or air inlet and outlet clear to
prevent the motor from overheating.
Notice
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorized specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug or the battery with wet or
damp hands.
•
Switch off the device.
•
Allow the device to cool down completely.
•
Remove the battery from the device.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
Inside the device, there are no parts that need to be maintained
or lubricated by the user.
Cleaning
The device should be cleaned before and after each use.
Notice
The device does not have to be lubricated after
cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Ensure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Dry the bits with a soft, lint-free cloth.
•
Keep the connecting terminals on the device and charger
clean.
•
Keep the connecting terminals on the battery pack clean.
•
Keep the ventilation openings free from dust deposits to
prevent overheating of the motor.
