3
EN
Operating manual – cordless glue gun PGGS 10-3,7V
General Power Tool Safety Warnings – Service
•
Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will
ensure that the safety of the power tool is maintained.
General Battery Pack / Charger Safety Warnings
•
Use power tools only with specifically designated
battery packs.
Use of any other battery packs may create
a risk of injury and fire.
•
When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys, nails,
screws or other small metal objects, that can make a
connection from one terminal to another.
Shorting the
battery terminals together may cause burns or a fire.
•
Recharge only with the charger specified by the
manufacturer.
A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
•
Do not charge other battery packs.
The charger is only
suitable for use with the supplied battery pack and with
the voltages specified in the technical data. Otherwise,
there is a risk of fire and explosion.
•
Under abusive conditions, liquid may be ejected from
the battery.
Avoid contact. If contact accidentally occurs,
flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause
irritation or burns.
•
In case of damage and improper use of the battery,
vapours may be emitted.
Provide for fresh air and seek
medical help in case of complaints. The vapours can
irritate the respiratory system.
•
Do not open the battery.
There is danger of a short
circuit.
•
Do not short-circuit the battery.
There is danger of
explosion.
•
Batteries must not be exposed to mechanical impacts.
•
Protect electrical parts against moisture. To prevent an
electric shock, never immerse them in water or other
liquids during cleaning or operation.
Never hold the
charger under running water. Please observe the
instructions for cleaning and maintenance.
•
The charger is only suited for indoor use.
•
Keep the charger clean.
Contamination entails a risk of
electric shock.
•
Do not operate the charger on highly combustible
ground (e.g. paper, textiles etc.) or in an inflammable
environment.
The heat generated by the charger during
charging entails a risk of fire.
•
Only use the charger for charging the battery.
The
charger must not be used as power supply for the power
tool.
Device-specific safety warnings for glue guns
•
Only place the device on fireproof, non-heat-
conducting and solid surfaces.
The heat generated by
the device during operation entails a risk of fire.
•
Do not use flammable solvents for cleaning the areas
to be glued.
Fire hazard.
•
Do not touch the nozzle or the glue stick.
The nozzle
and the glue stick can reach temperatures exceeding
170 °C.
•
Do not allow hot glue to come into contact with people
or animals.
In case of skin contact immediately hold the
affected area under a jet of cold water for several minutes.
Do not try to remove the glue from your skin.
•
Do not pull the glue stick out of the nozzle.
Touching
hot glue can cause severe burns and the power tool can be
damaged.
•
Never use the glue gun at ambient temperatures below
5 °C or above 50 °C.
•
Do not use the glue gun in an environment with direct,
cold wind.
The device's efficiency decreases and energy
is lost.
•
In case of continued use, do not apply excessive
pressure on the trigger.
The glue gun can be damaged.
•
Tasks which require the housing to be opened must
only be carried out by authorised specialist
companies.
•
If the glue escapes towards the rear, stop using the
tool immediately!
Have it cleaned by a specialist
company before further use.
Intended use
Only use the device
PGGS 10-3,7V
for bonding wood,
cardboard, packaging material, leather, ceramic, glass, carpet,
seals, plastic, fabric, cork and metal using hot-melt glue whilst
adhering to the technical data. The workpieces to be bonded
must be clean, dry and free of grease.
We recommend using the power tool with original Trotec
accessories.
