EN
15
cordless planer PPLS 10-20V
7. Let go of the on/off switch (
1
) to switch the device off.
Please note that the cutting head continues running for a
while.
1
8. Make sure that the lift-off device (
19
) folds down when the
device is lifted, and put the device down safely.
19
Chamfering edges
You can use the V grooves at the front base plate to chamfer
edges. These grooves determine the width of the chamfer and
additionally serve as a guide.
a
a
Groove used
Measure a (mm)
none
approx. 0 to 4
small
approx. 2 to 6
medium
approx. 4 to 9
large
approx. 6 to 10
Please proceed as follows to chamfer edges:
1. Position the front base plate on the edge of the workpiece
with the desired V groove (
6
). Make sure that the device is
positioned at an angle of 45° to the workpiece.
6
2. Guide the device along the edge while applying even
pressure.
