12
EN
cordless polisher PPOS 10-20V
Switching the device on and off
Wear your personal protective equipment when working with
the device.
1. Take the device into both hands by holding it on the
handles.
2. Place the polishing machine on the area to be treated.
3. Switch the device on by setting the on/off switch (
1
) to
position
I
.
1
4. Switch the device off by setting the on/off switch (
1
) to
position
O
. Only then remove the device from the surface
to be treated.
1
Shutdown
•
Switch off the device.
•
If required, allow the device to cool down.
•
Remove the battery from the device (see Start-up chapter).
•
Remove the polishing bonnet from the polishing disc.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Designation
Article number
Spare battery Multiflex 20-2.0 DC
6.200.000.303
Spare battery Multiflex 20-4.0 DC
6.200.000.320
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
•
Check whether the battery is inserted correctly in the quick
charger.
Slide the battery into the quick charger in a way that the
battery terminals engage in the quick charger. The battery
must lock in place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for damage.
•
Check the on-site fusing.
•
Check the quick charger for damage. If the quick charger
is damaged, stop using it. Contact the Trotec customer
service.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery might be defective and have to be replaced.
Only use batteries of the same type.
