EN
13
cordless polisher PPOS 10-20V
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check whether the battery is correctly connected to the
device.
Slide the battery onto the device in a way that the battery
terminals engage. The battery must lock in place in the
device.
•
Check the battery terminals for dirt. Remove any dirt.
Info
Wait for at least 10 minutes before switching the
device back on.
The motor is running but polishing the surface does not
work
•
Check whether you chose the appropriate polishing bonnet
for your current working step. Use the cloth polishing
bonnet for applying the polishing agent. Use the synthetic
fibre polishing bonnet for polishing the surfaces.
•
Check whether the polishing agent has lightly dried on the
entire surface. If the polishing agent is still wet, it will be
smudged by the synthetic fibre polishing bonnet.
•
Check whether you may have applied too much polishing
agent. Excess polishing agent will only make it more
difficult to remove the layer of the polishing agent on the
paint and does not improve the result.
The device becomes hot:
•
Keep the venting slots clear to prevent the motor from
overheating.
Info
Wait for at least 10 minutes before switching the
device back on.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorized specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug or the battery with wet or
damp hands.
•
Switch off the device.
•
Allow the device to cool down completely.
•
Remove the battery from the device.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
Inside the device, there are no parts that need to be maintained
or lubricated by the user.
Cleaning
The device should be cleaned before and after each use.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Make sure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Keep the connecting terminals on the device and charger
clean.
Cleaning the polishing bonnets
•
Only wash the polishing bonnets by hand and allow to air
dry.
•
Remove the polishing bonnet if you do not use it and store
the device with the polishing disc facing upwards in order
for the polishing disc to dry and to maintain its shape.
