EN
9
cordless polisher PPOS 10-20V
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Allow the device to cool down.
•
Remove the battery from the device.
•
Remove the polishing bonnet from the device.
The supplied Li-ion batteries are subjects to the requirements of
dangerous goods legislation.
Observe the following when transporting or shipping Li-ion
batteries:
•
The user may transport the batteries by road without any
additional requirements.
•
If transport is carried out by third parties (e.g. air transport
or forwarding company), special requirements as to
packaging and labelling must be observed. This includes
consulting a dangerous goods specialist when preparing
the package.
– Only ship batteries if their housing is undamaged.
– Mask open terminals with tape and pack the battery in
a way that it cannot move inside the packaging.
– Please also observe any other national regulations.
Storage
Before
storing the device, proceed as follows:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Allow the device to cool down.
•
Remove the battery from the device.
•
Remove the polishing bonnet from the polishing disc.
•
Clean the device as described in the Maintenance chapter.
•
Do not store Li-ion batteries which are completely
discharged. Storing discharged batteries can lead to a
deep discharge and thus damage the battery.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
Ambient temperature below 45 °C
•
protected from dust and direct sunlight
•
Store the device with the polishing disc facing upwards in
order for the polishing disc to maintain its shape.
Start-up
Unpacking the device
•
Take the device and the accessories out of the packaging.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
•
Check the contents for completeness and look for
damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
•
Dispose of the packaging material according to the
national regulations.