EN
14
Operating manual – cordless rotary hammer PRDS 10-20V
Selecting the rotational direction
Notice
Only change the rotational direction when the device is
at a standstill! Otherwise the device might be
damaged.
The motor's rotational direction can be changed by means of
the switch for clockwise/counter-clockwise rotation (3).
1. Press in the switch for clockwise/counter-clockwise
rotation (3) on the side to which the motor shall rotate.
I.
II.
3
I.
Unscrewing
II.
Screwing in
2. Carry out a short test run to see whether the rotational
direction matches the intended application. A wrong
rotational direction may damage the tool and / or
workpiece.
3. If required, set the switch for clockwise/counter-clockwise
rotation (3) to centre position (lock) to block the on/off
switch (4).
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Set the switch for clockwise/counter-clockwise rotation (3)
to centre position (lock).
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
If required, allow the device to cool down.
•
Remove the battery from the device (see Start-up chapter).
•
Remove the tool from the device (see Start-up chapter).
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Accessories
Article number
SDS drill bit and chisel set, 11-piece
6.205.001.101
Screw bit set, 32-piece
6.200.001.001
Spare battery Multiflex 2.0 Ah 20V
6.200.000.303
