EN
8
Operating manual – cordless rotary hammer PRDS 10-20V
Technical data
Parameter
Value
Model
PRDS 10-20V
Nominal voltage
20 V
Idle speed
0 – 900 rpm
Impact frequency
0 – 5000 bpm
Impact energy
1 J
Max. drilling diameter
Wood
Metal
Concrete
16 mm
8 mm
10 mm
Protection class
III /
III
Weight
1.5 kg
Battery
PRDS 10-20V DC
Type
Li-ion
Nominal voltage
20 V
Capacity
2.0 Ah
Quick charger
PRDS 10-20V AC
Input
Nominal voltage
230 – 240 V / 50 Hz
Power consumption
65 W
Output
Nominal voltage
21.5 V
Charging current
2.4 A
Charging time
1 h
Cable length
1.5 m
Protection class
II /
Vibration information according to EN 60745
Total vibration emission value:
Handle
Vibration emission value a
h(HD)
Uncertainty K
6.314 m/s²
1.5 m/s²
Additional handle
Vibration emission value a
h(HD)
Uncertainty K
4.580 m/s²
1.5 m/s²
Sound values according to EN 60745
Sound pressure level L
pA
82.38 dB(A)
Sound power level L
WA
93.38 dB(A)
Uncertainty K
3 dB(A)
Wear hearing protection.
Excessive noise can lead to hearing loss.
Information on noise and vibration:
•
The vibration level specified in these instructions was
determined by means of a measuring method standardized
in EN 60745 and can be used for a device comparison. The
specified vibration emission value may also be used for a
preliminary assessment of the exposure.
Caution
Vibration emissions can cause a health hazard if the
device is used for an extended period of time or if it is
not properly handled and maintained.
•
The vibration level will change depending on the
application of the power tool and may in some cases differ
from the value specified in these instructions. The vibration
load may be underestimated if the power tool is used
regularly in such a way. For a precise estimation of the
vibration load during a certain work period, it is also
important to consider the periods during which the device
is switched off, or is running but not actually employed.
This can reduce the vibration load over the entire work
period significantly.
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device, use the transport case included in
the scope of delivery in order to protect the device from external
influences.
Before
transporting the device, observe the following:
•
Switch off the device by setting the switch for clockwise/
counter-clockwise rotation to centre position (lock).
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Allow the device to cool down.
•
Remove the battery from the device.
•
Remove the tool from the tool holder.
The supplied Li-ion batteries are subjects to the requirements of
dangerous goods legislation.
