9
EN
Operating manual – rotary hammer PRDS 10-230V
Inserting and using the depth stop (optional)
With the depth stop you can determine the penetration depth of
the drill bits.
1. Loosen the fastening screw (2) at the mount.
2. Insert the depth stop.
7
2
3. Adjust the depth stop to the desired length.
4. Retighten the screw.
Using the key-type drill chuck (optional)
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
1. Push the SDS-plus system tool holder (1) to the rear and
hold it there.
2. Put the key-type drill chuck (7) into the SDS-plus system
tool holder (1).
1
7
3. Then release the SDS-plus system tool holder (1).
4. Check the key-type drill chuck (7) for tight fit.
5. Open the key-type drill chuck (7) by means of the drill
chuck key (8).
6. Insert the tool in the key-type drill chuck (7).
7. Tighten the key-type drill chuck (7) by means of the drill
chuck key (8).
7
8
