13
EN
Operating manual – rotary hammer PRDS 10-230V
The drill bit does not penetrate / hardly penetrates the
material:
•
Check whether the correct speed level is selected.
A higher speed level may be required in harder material.
•
The setting for drilling
or impact drilling
should be selected.
•
Check whether the correct drill bit is selected.
•
Check whether the function selector switch (3) is set to
position
. This position is only suitable for chiselling.
The chisel does not penetrate / hardly penetrates the
material:
•
Check whether the correct speed level is selected.
A higher speed level may be required in harder material.
•
Check whether the correct tool is selected.
•
Check whether the switch for the impact mechanism (12)
is set to position
. This position is only suitable for
drilling.
Info
Wait for at least 10 minutes before switching the
device back on.
The device becomes hot:
•
Check whether the tool is suitable for the tasks to be
carried out.
•
Keep the venting slots clear to prevent the motor from
overheating.
•
Select a lower speed.
Info
Wait for at least 10 minutes before switching the
device back on.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorized specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down completely.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
Inside the device, there are no parts that need to be maintained
or lubricated by the user.
Cleaning
The device should be cleaned before and after each use.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Ensure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Dry the bits with a soft, lint-free cloth.
•
Keep the ventilation openings free from dust deposits to
prevent overheating of the motor.
•
Remove any drilling dust and, if applicable, wood chips
from the SDS tool holder or key-type drill chuck.
•
Slightly grease the tool holder with machine lubricant
before inserting another tool.
