11 / 53
8018_SP1500
V2.2_EN (03/2018)
4.4 Mechanical Design
Working area
1500 x 1250 mm (59 x 49 in)
Feed area
1700 x 1600 mm (66 x 62 in)
Max. height of work piece
30 / 53 / 75 mm (1.18 / 2.08 / 2.95 in)
(3 work table levels)
185 mm (7.28 in) without work table
(flatness cannot be guaranteed without work table)
Speed of motion system
165 cm/s (65 in/sec)
Acceleration
9,55 m/s² (375 in/sec²)
Motor
Brushless DC servomotor
Encoder
Increment measuring system
Lenses
2,5
“ and 5.0” (Standard), 7.5” (optional)
Lenses and all reflective mirrors are air-flushed and
therefore protected from soiling (preinstalled air pump)
Max. area load of workpiece
table
25 kg (55 lbs) over entire working area
Precision
±0,1 mm (±0.004 inch) over entire working area
(depends on material)
Repeatability
< ±15 µm
(< ±0.00059 inch)
4.5 Control System
Laser power
Adjustable 0
– 100% (Typically 10-100%)
Hardware Interface
USB, RS-232 (RS-232 mandatory for TroCAM and i-Cut)
Software Interface
ASCII, HPGL, Trotec Protocol
4.6 Laser Tubes
Laser tubes
Sealed off CO2 laser, maintenance free,
Laser power of 60-400W
Wavelength
10,6 µm
Summary of Contents for SP1500
Page 1: ...SP1500 Operation Manual...
