EN
11
fan heater TFC 21 E
Switching the display on and off
Please proceed as follows to switch the control panel (
2
) on or
off:
1. Press the
Illumination
button (
23
) to switch the display off.
ð
The display switches off.
2. Press any button to switch on the device.
ð
The display switches on.
Using the oscillation function
ü
The device is switched on.
1. Press the
Oscillation
button (
15
) once to activate the
oscillation function.
ð
The oscillation function is activated.
ð
The device turns to and fro by up to 80°.
2. Press the
Oscillation
button (
15
) again to deactivate the
oscillation function.
ð
The oscillation function is deactivated.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
Note
In order to dissipate the accumulated heat, the fan
keeps running for approx. 30 seconds after the device
has been switched off and then switches off
automatically.
After 12 operating hours, the device switches off automatically.
The illumination of the display is dimmed after 1 minute if no
buttons are pressed.
1. Switch off the device by pressing the On/Off button (
26
).
ð
The fan keeps running.
2. Set the On/off switch (
7
) to
0
.
ð
The device is switched off.
3. Allow the device to cool down sufficiently.
4. Hold onto the mains plug while pulling the power cable out
of the mains socket.
5. Clean the device according to the Maintenance chapter.
6. Store the device according to the Storage chapter.
Errors and faults
Warning of electrical voltage
Tasks which require the device to be opened must
only be carried out by authorised specialist
companies or by Trotec.
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
•
Check the power connection.
•
Check the power cable and mains plug for damage. If you
notice damages, do not try to take the device back into
operation.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
•
Check the on-site fusing.
•
Check the room temperature. The room thermostat may
have switched off, because the desired room temperature
has been reached.
•
The motor might be defective. Have a defective motor
replaced by a specialist electrical company.
•
Check whether the device is standing upright and on level
ground. The tilt protection may have been tripped owing to
the fact that the device was knocked over. Always put up
the device in an upright position on a suitable, sufficiently
dimensioned surface.
•
The room thermostat might be defective. Have a defective
room thermostat replaced by a specialist electrical
company.
•
The overheating protection may have been tripped. Have a
specialist electrical company or Trotec check the electrics
and replace the overheating protection.
•
Wait for 10 minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.