EN
5
fan heater TFC 21 E
Behaviour in the event of an emergency
1. Switch the device off.
2. In an emergency, disconnect the device from the mains
feed-in: Hold onto the mains plug while pulling the power
cable out of the mains socket.
3. Do not reconnect a defective device to the mains.
Overheating protection
The device is provided with a safety thermostat which is
activated by overheating of the device (when exceeding the
operating temperature).
Once the safety thermostat has switched itself on, the device
will be turned off.
When the device has cooled down sufficiently, it has to be
switched back on manually.
Investigate the cause of overheating.
If the safety thermostat does not switch in the event of
overheating, the overheating protection will be tripped. In that
case the device switches off completely. If so, please contact
the customer service to have the overheating protection
replaced.
Tilt protection
The device comes equipped with a tilt protection sensor. The tilt
protection is a safety device intended to minimize the risk of fire
in case the device is tipped over inadvertently. The device will
be switched off when knocked over (or if its upright position is
changed in any other manner).
The tilt protection switches the device off when it is inclined by
a few degrees out of its vertical position. The tilt protection is
also tripped when lifting the device a little, e.g. for transport
during operation. The device can again be used as usual only a
few seconds after placing it back in vertical position and on
solid ground.
Information about the device
Device description
The ceramic heater serves to generate and distribute warm air,
e.g. in interior spaces.
The device generates heat by means of a ceramic heating
element. The surrounding air is sucked in and heated in the
interior of the heater. The heated air is blown into the room by a
fan.
The device is equipped with an integrated thermostat and so
generates a constant flow of warm air. In addition, you can set a
desired target temperature (15 °C to 35 °C) at the device.
The device is further equipped with an overheating protection
and an integrated tilt protection.
Moreover, the device comes with an on-demand 80° oscillation
for an even better distribution of the warm air in the room.
In order to dissipate the accumulated heat, the fan keeps
running for approx. 30 seconds after the heater's switch-off and
then switches off automatically.
