EN
7
fan heater TFC 21 E
Assembly and start-up
Scope of delivery
•
1 x Fan heater
•
1 x Remote control
•
1 x Foot
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
Foot assembly
1. Set up the foot (
4
).
2. Remove the sticker at the bottom of the device before
mounting the foot.
3. Attach the device on the foot (
4
) from above so that the
clips (
9
) on the device are exactly aligned with the
recesses at the foot (
4
).
4. Press the device down to fasten it on the foot (
4
).
4
9
ð
The foot (
4
) clicks into place on the clips (
9
) of the
device.
5. Check the foot (
4
) for tight fit.
6. Set the device up in an upright and stable position.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D