8
Commissioning/functional
test
8.1 Commissioning
Before commissioning, each smoke control damper
must be inspected to determine and assess its actual
condition,
‘Inspection, maintenance and repair
.
The movement of the damper blades may over time
lead to grooves in the side seals (where the blades
meet the casing); this does not impair the function of the
damper. The damper blades seals adapt themselves to
the seal and can compensate for the smallest devia-
tions.
Important: Install the smoke control damper without tor-
sion (horizontal/vertical).
8.2 Functional test
General
Smoke control dampers must be checked regularly. A
functional test involves closing the smoke control
damper and opening it again. This is typically done with
an input signal from the central fire alarm system.
Commissioning/functional test
Functional test
Smoke control damper EK-JS
49
Summary of Contents for EK-JS
