ð
When the connection has been established, a
window opens and the script is executed.
Fig. 43: Script window
Fig. 44: Start menu
6.
Go to the Start menu and select
‘Control Panel’
.
Fig. 45: Control panel
7.
In the
‘Control Panel’
window click on
‘Network
and Dial-up Connections’
.
Fig. 46
8.
In the next window select
‘TCCCAMTMP1’
.
The
‘'TCCCAMTMP1 Ethernet Driver' Setting’
window opens.
Select
‘Specify an IP address’
and enter the
required network settings.
Confirm your entries with
‘OK’
and close the
‘Control Panel’
window.
The new settings are immediately active; you
need not restart the computer.
9.
Remove the network cable from port X001 and
connect the touch panel again.
Connect the BMS computer to port X101.
You can use port X102 as described above.
5.10.2
X-CUBE controller CX9020
Integration with the network, setting the IP address
Personnel:
HVAC technician
Skilled qualified electrician
Network administrator
For more information refer to
https://infosys.beckhoff.com/content/1031/cx9020_hw/
index.html?id=1759
Installation
Connecting the controls to your PC or local netw... > X-CUBE controller CX9020
Air handling unit X-CUBE X2 / X-CUBE X2 compact
46
