Model 2701-B
2–13
2. GETTING STARTED
MIX CALIBRATION
The
Mix Calibration
function is used to adjust gauge measurements,
as described on page 3–6.
LAYER THICKNESS
The
Layer Thickness
function enables the operator to enter the
thickness of the material being measured. When this function is
enabled, the gauge prompts the operator to enter a thickness value
when creating a new
project
as described on page 5–4. The layer
thickness value is then stored along with other measurement data in
the active project.
To enable or disable the
Layer Thickness
function, press
〈
8
〉
on the
Setup
menu shown on page 2–7. The gauge displays:
Thickness Option
1. ON
2. OFF
Press # to Select
Press
〈
1
〉
to enable the
Layer Thickness
function or
〈
2
〉
to disable it.
The gauge sets the function to the desired state, displays a brief
confirmation message, and returns to the
Setup
menu.
Summary of Contents for 2701 -B
