Assembly
Positioning the Upper Handle
Making sure not to pinch the cable in the process, pivot the
upper handle into the operating position as illustrated in
Figure 3-1 until it clicks into place.
Tighten the wing knobs to secure the handle in place as in
Figure 3-1.
Assembling the Discharge Chute
For shipping reasons, the snow thrower has been packaged with
the upper chute pivoted all the way down. To pivot it upward,
proceed as follows:
NOTE:
Turn the chute until the chute opening is facing straight
ahead.
Remove the wing knob, flat washer and carriage bolt from
the lower chute. See Figure 3-2.
1.
2.
1.
Pivot the upper chute upward over the lip on the lower
chute so that there is NO gap between the upper chute
and the lower chute.
Secure with the hardware just removed. Refer to Figure 3-3.
2.
3.
Figure 3-2
Figure 3-3
Figure 3-1
Contents of Carton
Two Ignition Keys
•
One 20 oz. Bottle 5W-30 Oil
•
One Extension Cord
•
One Snow Throwers Operator’s
Manual
•
One Tecumseh Engine Operator’s
Manual
•
Chute Handle
Assembly & Set-Up
3
6
