22
Changing the Deck Belt
WARNING: Be sure to shut
the engine off, remove ignition
key, disconnect the spark plug
wire(s) and ground against the
engine to prevent unintended
starting before removing the
belt(s).
The belt on your tractor is subject to wear and should be
replaced if any signs of wear are present.
IMPORTANT
: The V-belt found on your tractor are
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
use a factory approved belt.
To change or replace the deck belt proceed as follows:
1. Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
2. Remove the belt guards by removing the self-tapping
screws that fasten them to the deck.
3. Remove the belt keeper rod from around the engine
pulley.
4. Insert a 3/8”-drive ratchet wrench (set to loosen) into
the square hole found in the idler bracket on the left
side of the deck’s surface. See Figure 20.
5. Grasp the ratchet’s handle and pivot it toward the front
of the tractor to relieve tension on the belt.
6. With belt tension relieved,
carefully remove the belt
from around the left-hand spindle pulley.
6
Maintaining
Your Lawn
Tractor
����������������
�������������
Figure 20
WARNING
Be sure to shut the
engine off, remove ig-
nition key, disconnect
the spark plug wire(s)
and ground against
the engine to prevent
unintended starting
before removing the
belt(s).
IMPORTANT
: Carefully allow the ratchet to pivot rearward
before removing it from the square hole.
WARNING: Avoid the possibility
of a pinching injury. Do not place
your fingers on the idler spring
or between the belt and a pulley
while removing the belt.
7. Remove the deck belt from around all pulleys, including
the deck idler pulley.
8. Route the new belt as shown in and Figure 21.
9. Remount the belt guards removed earlier.
Changing the Transmission Drive Belts
NOTE
: Several components must be removed and special
tools (i.e. air/impact wrench) in order to change the
tractor’s drive belts. See an authorized Troybilt Service
Dealer to have your drive belts replaced. To find a dealer
near you, phone our dealer locator number as instructed
on page 2 or log onto www.troybilt.com.
Avoid the possibility of
a pinching injury. Do
not place your fingers
on the idler spring or
between the belt and a
pulley while removing
the belt.
Summary of Contents for 77T Series
