10
s
ectiOn
3 — a
sseMbly
& s
et
-u
p
IMPORTANT:
Be certain to attach the smaller, rear channel
on each side of the bag to ensure the proper fit of bag.
Refer to Fig. 3-4.
Attach center top of bag from inside of frame.
c.
Before attaching the grass catcher, the rear mulching baffle
2.
must be removed.
Lift rear discharge door.
a.
Remove rear mulching baffle. See Fig. 3-5.
b.
Follow the steps below to attach the grass catcher:
3.
Lift rear discharge door. See Fig. 3-6.
a.
Place grass catcher on the pivot rod. Let go of
b.
discharge door so that it rests on the grass catcher.
Hold blade control against upper handle.
a.
Pull starter rope out of the engine. Release blade
b.
control.
Slip starter rope into rope guide.
c.
Tighten wing nut.
d.
Grass Catcher
Follow steps below to assemble the grass catcher. Make
1.
certain bag is turned right side out before assembling
(warning label will be on the outside).
Place bag over frame so that its black plastic side is
a.
at the bottom. See Fig. 3-4.
Slip plastic channels of grass bag over hooks on
b.
the frame. Begin with the bottom channel, then
proceed to the side channels. All the plastic channels
except center top of bag attach from outside of
frame.
A
C
D
B
Figure 3-3
Figure 3-4
A
C
B
Rear Channel
Figure 3-5
B
A
Figure 3-6
Summary of Contents for 860 series
Page 39: ...Notas 9 19...
