Assembly & Set-Up
3
7
Assembly
Installing the Discharge Chute
A discharge chute, wire spring, and chute band, have been
included with this attachment. Please assemble them now
by installing the discharge chute onto the snow thrower by
following these steps:
1.
Install the wire spring into the discharge opening of
the snow thrower by inserting both ends into the
slots provided. See Figure 3-1 for proper location and
orientation of the spring. The inset of Figure 3-1 shows the
spring properly installed with the ends fitted into the slots
provided.
NOTE:
Place some of the white lithium grease provided on
the wire spring and chute adapter ring prior to assembly as
shown in Figure 3-1.
Figure 3-1
2.
Install the discharge chute, packed loose in the carton,
onto the snow thrower attachment, as shown in Figure 3-2.
Figure 3-2
Note:
Position the discharge chute at an angle to the right
for ease of installation.
IMPORTANT:
Apply white lithium grease (included with
this attachment) onto the chute ring, chute spring, and
chute adapter ring prior to assembly.
3.
Clip the discharge chute handle onto the discharge chute,
as shown in Figure 3-3.
Figure 3-3
Summary of Contents for FLEX 23AABA6X711
Page 20: ...Notes 10 20 ...
